QO-TDCC8 first setup: from the Ethernet link to the first correlation
Steps to connect the device, reach its embedded web interface and take a first correlation measurement.
Connect the device
Connect the device to your computer or local network with an Ethernet cable and power it on.
Open the embedded interface
Open the device’s IP address in your browser. The interface is served by the device itself; no driver is needed.
Connect the detectors
Connect the detector outputs to the CH 1 and CH 2 inputs and watch both count rates in the control panel.
First correlation measurement
Select the CH 1 × CH 2 correlation on the histogram screen, set the bin width and measurement time, and start the measurement.